Syslog audit device
syslog audit device writes audit logs to syslog.
It currently does not support a configurable syslog destination, and always sends to the local agent. This device is only supported on Unix systems, and should not be enabled if any standby Vault instances do not support it.
Warning: Audit messages generated for some operations can be quite
large, and can be larger than a maximum-size single UDP
packet. If possible with your
syslog daemon, configure a TCP listener. Otherwise, consider using a
backend and having syslog configured to read entries from the file; or, enable
syslog so that a failure for a particular message to log
syslog will not result in Vault being blocked.
syslog device can be enabled by the following command:
$ vault audit enable syslog
Supply configuration parameters via K=V pairs:
$ vault audit enable syslog tag="vault" facility="AUTH"
syslog audit device supports the common configuration options documented on
the main Audit Devices page, and
these device-specific options: